810 Deflector

[urethane dino]

Does anyone have a rough number as to what this option costs?
Dino

[Jerre Heyer]

$158

[urethane dino]

I decided to build my own deflector and save a few $$$
I had the piece of rubber, and bought some cheap angle iron with holes already in it. Stuff found at local hardware stores. All told it cost me less than 10.00
I bolted the angle together to make a c channel. All pieces are 24" long all bolts are 5/16 and fender washers on the front to hold down the rubber. I will see how that works out, if they arent up to the challange, and will use some flat stock.

[urethane dino]

pic from the back

[urethane dino]

close up of the angle iron

[urethane dino]

Had to clip the corners of the angle iron so the wings can pitch forward.

[urethane dino]

Last one was passenger side, here is drivers side

[Prosno]

After spending he money I did on two of these plows I spent the 158.00 why cut costs now? the factory unit looks and works good and doesnt look like I made it with an erector set.

[Prosno]

Pelican what are you running on you 810? I thought I seen a factory unit also

[Pelican]

I don't have a deflector on my 810.

[PSDF350]

heres mine

[Lawngodfather]

Mine