HOSES - Is this right??

[4evergreenlawns]

After having plowed twice for several hours I have started looking close at the 810's to see it anything is/has gone wrong. I found a few things that need to be tightened but that is about it.

However, the hoses look to be routed strange. I took a few pics and would like to show them and see if they are corect. I would think they go over the A frame to the torque box not under.

Take a look.

Thanks

[4evergreenlawns]

hanging low??

[NYRookie]

Just went out and looked at mine. They are the same way, hanging down, though yours look lower than mine.

[4evergreenlawns]

the pics are with the blade hard left which push the left side hoses down and same on the right went to the right.

Thanks for taking the time to look.

[Lawngodfather]

MIne don't hang that low

[4evergreenlawns]

Mike,

Are they going from the pump over the A frame than to the box? Mine run under the A frame.

[Jerre Heyer]

Routing is correct on the hoses. Remember as you angle they have to move a little and will hang lower on the side the blade is angled to.


Jerre

[4evergreenlawns]

Thanks Jerre just wanted to be sure.

[urethane dino]

I looked at mine today and the hoses are above the angle cyl.
Dino

[Arc Burn]

Originally posted by urethane dino
I looked at mine today and the hoses are above the angle cyl.
Dino

Well thats just ridiculos,send that damn thing back:argue
Dino and a Blizzard..what next,JohnnyD and a Duramax:huh
I think the suns about to fall out of the sky:D
Don't hit anything hard Dino,remember,we saw pics of a bent one once!

[urethane dino]

Tell you what, you would see JD in a duramax before and PS. He is the main reason I bought the 810.
Dino

[Jerre Heyer]

Easy now Dino....He will ride in my PS 6.0 when I get it
LOL


Jerre

[urethane dino]

My hoses are over the angle cyl, and then through a hole in the front quadrant beam to the wing cyl.
Dino

[Jerre Heyer]

Dino, that would be quite a stretch to take them over the angle cyl but I'll believe you. Over the angle iron piece I could see easily but we had problems with running them that way. Extreme angle and tripped on the blade caused them to wear on the angle and the quadrant holes.

May the Get Wide be with you.......

[urethane dino]

Here is a pic of my hose routing.

[urethane dino]

pic 2

[4evergreenlawns]

Dino,

Thanks, that is what I had in mind when I was looking at them hanging down.

[urethane dino]

You are welcome. I am glad I finally figured out this pic posting thing. You know what I got the blizzard and then figured out the posting deal, see blizzards do get you smart.
Dino

[Lawngodfather]

Originally posted by urethane dino
But once you have personally seen the time savings your tune will quickly change.
I know mine did. I was wrong I was wrong I was wrong, every thing that has been said about the blizzard 810 is true and then some.

Dino Ya put it there