How to test harness and slick stick

[D-Page]

Hey guys, need your help on How to test harness and slick stick? Pump is a E47. Plow wouldn't go up. Fluid good. Changed both B valve and coil. When switch is operated to go up the plow angles left to the driver's side. When I switch the red and green wires on the pump to the harness, I get the plow to go up. But I pin the plow in the straight position so that I get the blade to at least go up & down. Any help appreciated

[D-Page]

Anybody out there that can help me??

[snowjoker]

Sounds to me like a stuck valve... I am not a meyer expert but you can go on their website at the top of the page and get the manual for that pump.

[The boys]

your b valve is stuck pull the valve out stick a #2 screwdriver in bottom of it and push down. and i dont want to hear that its brand new either. i see brand new bad parts all the time.

[D-Page]

Thanks Joker and The Boys.... going to try that tomorrow

[Chuck Smith]

When I switch the red and green wires on the pump to the harness, I get the plow to go up.

I realize I am late to this party, but if switching the wires makes it go up, then you have a break in the harness or a bad Slik Stik.

~Chuck