Moving an O2 sensor on a 94 k1500

[Fast Eddie]

I finally got a set of Edelbrock full length headers to replace the flow techs on my truck. One thing I noticed is there is no port for the O2 sensor to screw into where the Y pipe comes together, instead there is a spot on the driver side header.
My question is if I install these headers and move the O2 sensor over will it hurt anything?

Thanks
-e

[wyldman]

No,it won't hurt anything,and it should be fine on either side.

If you want to keep it where it is,you can always weld another bung onto the pass side header.

[Fast Eddie]

Originally posted by wyldman

If you want to keep it where it is,you can always weld another bung onto the pass side header.

I wish... I can't weld 16 ga without burning holes through it;) , need more practice I guess.

Thanks for the reply...