Help with angle ram

[jeffl1107]

Hello,
Just fixed a motor problem with my meyers 7.5 plow E60, and now I have a angle ram problem.
Ok, I can angle the plow to the drivers side, right ram extends all the way, but when I try and go back the other way, it does not go. I took the quick connect couplers off the lines, bled them, put new oil in them. I then connected both hoses together and the rams manually go back and forth with no problem. Again, hooked them up to the pump and the same thing. It will only angle to the drivers side. And when I hit the touch pad to go the other way, I can here the pump motor actuate, but nothing happens. Since I could manually move the rams back and forth, I dont see it being the lines or the couplers on the hoses. Could this be a bad connector on the pump itself???
***Oh and by the way, when I try and remove the quick connector on the right ram, (the one that does work), I cannot remove it unless I loosen the quick connector at the hose to bleed off. It seems like it has big time pressure build up.***
Not sure where to go from here. Any help would be appreciated.
Jeff:mad:

[festerw]

Sounds like the couplers are bad to me, hence the pressure build up.

[Z-MAN]

I had one like this a few years back. The angle valve swelled up and wouln't release the coil. Try removing the angle coil from the valve. Should either be a bad coil or valve.