V blade cutting edges

[ratlover]

Am I out of my mind? :rolleyes: I thought there was a company that makes edges for V blades that get rid of the rubber center wiper on the fisher and western and the center hoof on the older Boss?

Links or name or a supplier would be greatly appeciated. Thanks :)

Edit: Ment to stick this in the acessories section. :o

[snowplowjay]

Boss makes edges now that eliminate the center hoof as well as curb edges built right in......


Jay

[P&DDennis]

My new Extreme V has a four piece 2 flat 2 rounded. Dont know if they will adapt to the older style? Just insalled on Sat. and no snow yet to try it out. Wore out my old EZ Vee after 6 years.Good luck. Also ordered the curb protectors today. Wore the pin mounts off my old one a few times.

[ratlover]

The new xtreme V edges wont mount to the old blade.

[GMC Driver]

I've got them on the Boss Vs - they have the curb guards and center hoof eliminator tabs (for lack of a better name). Not sure if they are Boss OEM or made by another source.

I get mine at www.snowplowparts.ca

It's a Canadian site - not sure if that's going to help you Philip.

[nsmilligan]

These are the edges I made for my X-V, they'll also work on an EZ-V just need a 5/8" drill.
http://www.letstalksnow.com/forums/showthread.php?t=18818
Bill

[ratlover]

Thanks for the link :)

Have carbides on it now and they do wear REALY well. With the EZV I'm thinking I'm SOL without some modding I guess becasue the base edge dont leave room I suppose.

They make bolt on carbides for the EZV. I liked your directions for install though :cool: The "bolt on" carbides were a lil to long in the middle and I had to do some triming and had to do exactly how you did, nothing fazes the carbide except a whack with a hammer