Coldblue
01-11-2004, 08:52 AM
i had a local dodge dealer update my truck and install and activate the coldweather high idle and 3 cyl disable. but its been cold here and below the specs that the tsb says it is supposed to activate and doesnt, any ideas? i figured that maybe one of the sensors (iat or coolant temp sensor) are out of range? will it activate if the truck is plugged in?
i just replaced my rear brake shoes and grease seals because the were leaking. now it seems that the brake pedal travels a little farther than it should. is there a proportioning valve out of adjustment? or the mechinism attached to the rear end? it also seems that the rear brakes do kinda get warm. if you push the pedal 2 or 3 x's is gets better. dont get me wrong, the truck stops a lot better but seems it travels about 1-11/2 inches father than it should. and again in could be in my head????
i just replaced my rear brake shoes and grease seals because the were leaking. now it seems that the brake pedal travels a little farther than it should. is there a proportioning valve out of adjustment? or the mechinism attached to the rear end? it also seems that the rear brakes do kinda get warm. if you push the pedal 2 or 3 x's is gets better. dont get me wrong, the truck stops a lot better but seems it travels about 1-11/2 inches father than it should. and again in could be in my head????